Troubleshooting the Kivo app
Fixes for the most common problems with adapters, sensors, CAN signals and alerts.
My OBD2 adapter doesn't appear in Found nearby
Adapters that use Bluetooth Classic must be paired in the phone's Bluetooth settings first; after that they appear in the app automatically. That's Android only: on an iPhone, use a Bluetooth LE adapter. Bluetooth LE adapters with unusual names may not be recognized as OBD2, and pairing them in the phone's settings first helps. See supported adapters.
Values show "?" or "—", or update slowly
"?" or "—" means there's no reading yet: check that the device providing it is connected. Slow updates usually mean many values are being polled at once (see how fast OBD2 updates). Remove tiles and switch off alarms you don't need, and remember budget adapters are slower.
A tire sensor shows no data
Sensors sleep when the wheel isn't turning: ride a short distance or change the pressure slightly. If the bike was recently out of range, readings were cleared on purpose after 6 minutes of silence, and they come back with the next broadcast.
My CAN signals never show values
Check, in order:
- A DBC file is loaded for this profile.
- The Kivo Core is in CAN / OBD2 mode, or the adapter's data mode is CAN Bus and it's an STN-chip adapter.
- The signal's message actually appears on the bus you're connected to (many vehicles have several buses).
- The signal uses a standard 11-bit ID.
The Kivo Core's details screen has a CAN Self-Test (checks its own CAN hardware, no vehicle needed) and Bus status (live error counters) to tell a wiring fault from a quiet bus. OBD2 adapters have an Adapter Self-Test and Bus status too.
The trouble-code scan says "No OBD2 adapter"
Diagnostics needs a live OBD2 connection: an adapter connected and polling, or a Kivo Core in CAN / OBD2 mode with recent firmware.
Alerts stop when the app is in the background
Alerts continue while something is active (a vehicle connected, or a ride recording). If the phone's battery saver closed the app, exempt Kivo from battery optimization in the phone's settings. If you tapped Shut Down, monitoring stays off until you open the app again.
Two phones for one bike?
Use Share Device on the Kivo Core's details screen (see the Kivo Core). Only one phone connects at a time.